IC693MDL930 OUTPUT RELAY 4A 8PT ISOLATED GE FANUC PLC EMERSON COMMUNICATION PLC I/O MODULE

IC693MDL930 OUTPUT RELAY 4A 8PT ISOLATED GE Fanuc PLC

Product Details:

The GE Fanuc IC693MDL930 is a 4 Amp Isolated Relay Output module.

Designed for the Series 90-30 Programmable Logic Controller, this module provides 8 normally-open relay circuits.

These enable the user to control output loads. Each circuit has a 4-amp output switching capacity.

Each output point on the module is isolated from the other points and each point has a separate common power output terminal.

Rated Voltage

24 volts DC, 120/240 VAC (nominal - see the following table for exceptions)

Operating Voltage

5 to 30 volts DC

5 to 250 VAC, 50/60 Hz

Outputs per Module

Eight isolated outputs

Field to Backplane and to Frame Ground

250 VAC continuous;

1500 VAC for 1 minute

Point to Point

250 VAC continuous; 1500 VAC for 1 minute

Maximum Load

4 Amps resistive maximum per output

2 Amps pilot duty per output

20 Amps maximum per module for UL installations

Maximum Load depends on the ambient temperature as shown below

Minimum Load

10mA

Maximum Inrush

5 Amps

On Response Time

15ms maximum1

Off Response Time

15ms maximum1

Power Consumption

6mA (all outputs on) from 5 volt bus on backplane

70mA (all outputs on) from relay 24V bus on backplane

When this module is used with DC power supply IC695PSD040 or PSD140, special precautions should be taken because dropouts in the source voltage will be seen by this module and may cause relay dropouts.​

Ic693mdl930

GE Fanuc Emerson

ge fanuc plc ethernet communication

IC693MDL930 OUTPUT RELAY 4A 8PT ISOLATED GE FANUC PLC EMERSON COMMUNICATION PLC I/O MODULE Images